Update PX4 Firmware metadata Wed Sep 8 20:32:14 UTC 2021

src/FirmwarePlugin/PX4/PX4ParameterFactMetaData.xml

@@ -851,7 +851,7 @@
     </parameter>
     <parameter name="TRIG_PINS" default="56" type="INT32">
       <short_desc>Camera trigger pin</short_desc>
-      <long_desc>Selects which FMU pin is used (range: AUX1-AUX8 on Pixhawk controllers with an I/O board, MAIN1-MAIN8 on controllers without an I/O board. The PWM interface takes two pins per camera, while relay triggers on every pin individually. Example: Value 56 would trigger on pins 5 and 6. For GPIO mode Pin 6 will be triggered followed by 5. With a value of 65 pin 5 will be triggered followed by 6. Pins may be non contiguous. I.E. 16 or 61. In GPIO mode the delay pin to pin is &lt; .2 uS. Note: only with a value of 56 or 78 it is possible to use the lower pins for actuator outputs (e.g. ESC's).</long_desc>
+      <long_desc>Selects which FMU pin is used (range: AUX1-AUX8 on Pixhawk controllers with an I/O board, MAIN1-MAIN8 on controllers without an I/O board). The PWM interface takes two pins per camera, while relay triggers on every pin individually. Example: Value 56 would trigger on pins 5 and 6. For GPIO mode Pin 6 will be triggered followed by 5. With a value of 65 pin 5 will be triggered followed by 6. Pins may be non contiguous. I.E. 16 or 61. In GPIO mode the delay pin to pin is &lt; .2 uS.</long_desc>
       <min>1</min>
       <max>12345678</max>
       <decimal>0</decimal>